US Dollars
EasyPro ACF2N 24" Floating Fountain Head w/ Wide Umbrella Nozzle
Write a Review
EasyPro
EasyPro ACF2N 24" Floating Fountain Head w/ Wide Umbrella Nozzle
- Functions as a universal fountain head.
- Includes a Wide Umbrella Fountain Nozzle that creates the classic wide V water pattern.
- Easily turn a submersible pond pump (sold separately) into a fountain.
- Fountain nozzle comes complete with a 24 inch wide high density float and a decorative float cover as well.
- Spray nozzles thread on and off for easy fountain spray pattern changes or for cleaning.
- Inlet connection on Float: 2" FPT.
- Recommended pump sizes: 3,500 gph - 10,000+ gph (depending on application).
Videos Hide Videos Show Videos
This nearly universal fountain head is an excellent way to build your own fountain. The included nozzle is a Wide Umbrella that produces a classic wide V water pattern. This fountain head is built into a float, allowing your fountain to be placed in various water depths; anywhere from approx. 3 ft. deep to even the deepest ponds or lakes.
This fountain head can connect to external pumps, submersible pumps, and even an irrigation system! The fountain float includes 2 stainless steel eye hooks connected to the bottom of the float to tether the float if a submersible pump is used (rope tethers not included).
Please Note:
Use your own pump or choose one of ours!
Alternative nozzles may be purchased here.
Spray pattern and height will vary depending on the power of the pump used. See Chart under SPECS Tab.
Refer to the table below to determine approximate spray pattern and height.
| FOUNTAIN PERFORMANCE CHART | WIDE UMBRELLA NOZZLE | ||
|---|---|---|---|
| Spray Pattern | 4'H x 15'W | 6'H x 20'W | 8'H x 24'W |
| Pump GPH | 3720 | 4620 | 4920 |
| Feet of Head | 11' | 14' | 19' |
Helpful Hints on Pump Selection:
If a smaller pump (3500-5000 GPH) is used, a direct drive pump with a maximum head height of ideally over 20 ft should be selected and the pump should be attached directly beneath the float. Larger pumps should also be attached directly beneath the float for best performance. Larger pumps can also be connected to the float by a short (3-10 ft) run of 2" ID or larger piping, but keep in mind this will result in reduced water flow at the nozzle. So, increasing the distance between the pump and your fountain, the use of smaller than 2" ID hose, elbows, check valves, etc., will all result in a reduced flow of water at the nozzle. Best Advice: Keep the distance between your pump and the Floating Fountain Head as short as possible with minimal fittings for the best Fountain Display!
- Functions as a universal fountain head.
- Includes a Wide Umbrella Fountain Nozzle that creates the classic wide V water pattern.
- Easily turn a submersible pond pump (sold separately) into a fountain.
- Fountain nozzle comes complete with a 24 inch wide high density float and a decorative float cover as well.
- Spray nozzles thread on and off for easy fountain spray pattern changes or for cleaning.
- Inlet connection on Float: 2" FPT.
- Recommended pump sizes: 3,500 gph - 10,000+ gph (depending on application).